Rear View - HP D6030A - NetServer - E50 Installation Manual

Chapter 2
NOTE For more information on a HP Backup Tape Drive and its error
codes, refer to the documentation provided with the tape drive
or refer to Hewlett-Packard's web site at:
http://www.hp.com
Refer to Chapter 4, "Installing Mass Storage Devices," for
installation information.

Rear View

The ports and connectors on the NetServer's rear panel are shown in Figure 2-3
and listed below.
The Serial Port A is a standard serial connector.
The Serial Port B is a standard serial connector.
The Parallel Port is a standard parallel connector, which supports Extended
Capabilities Port (ECP)/Enhanced Parallel Port (EPP).
The Mouse Port accepts a standard mouse with a PS/2 connector.
The Keyboard Port accepts a standard keyboard with a PS/2 connector.
The Video Port connector is provided by an AGP board, with its relevant
specifications listed in the "Video Display Modes" section of Appendix A,
"Specifications."
The Power Connector accepts a standard power cable to connect the HP
NetServer E 200 with the site power supply.
The external SCSI connector can be provided by the SCSI Controller board
inserted into PCI slot 1. However, it can't be used if the internal 68-pin
connector on the SCSI controller board is used to control internal SCSI
drives.
8
Controls, Ports, and Indicators