Installing Additional Boards; Introduction; Tested Pci Boards; Tools Required - HP D6030A - NetServer - E50 Installation Manual

6 Installing Additional Boards

Introduction

This chapter describes how to install accessory boards into the system board of the
HP NetServer E 200. The HP NetServer includes four PCI slots and one ISA slot.
See Figure 6-1.

Tested PCI Boards

For a list of tested PCI boards, check for compatibility under the Hardware Tested
Products list for the HP NetServer E 200 under the Service and Support topic for
the specific NOS used in the NetServer at HP's web site:
http://www.netserver.hp.com
CAUTION
NOTE

Tools Required

The following tools will be required to install or remove accessory boards into the
HP NetServer.
Torx T-15 or ¼-inch flat blade screwdriver
Anti-static services kit (3M 8501/8502/8503 or equivalent) - This kit
includes a static-dissipating work surface, a chassis clip lead, and a
wrist-strap
Some accessory board outputs may exceed U.S. National
Electrical code (NFPA 70) Class 2 or limited power source
limits and must use appropriate interconnecting cabling in
accordance with the National Electrical Code. (All
Hewlett-Packard boards comply with Class 2.)
The HP NetServer E 200 does not support HP NetRAID boards
or Disk Array Controller (DAC) boards.
35