HP D6030A - NetServer - E50 Installation Manual page 57

Chapter 8
2. Flexible Disk Drive
3. IDE Hard drive (if the boot drive)
4. SCSI A Channel (provided by SCSI Controller board)
5. PCI slot 1
6. PCI slot 2
7. PCI slot 3
8. PCI slot 4
9. ISA slot
To change the boor order, refer to the following procedure.
1. Select "Boot" from the menu bar using the left or right keys, and press
<Enter> to open the menu.
A Boot setting screen appears, very similar to the one below.
1. Removable Device
2. IDE Hard Drive
3. ATAPI CD-ROM
4. Other Boot Device
The list provides the current boot order of the internal device types. If the
IDE Hard Drive selection is moved to the top of the boot list, it will use the
hard drive you select in Steps 3-4 to boot the NetServer. If a bootable SCSI
Disk Controller board is used, the controller board must be set up in the
SCSI Configuration utility after "Other Boot Device" is moved to the top
of the boot order.
2. Use the down- or up-arrow key to move to the device type field.
a. Use the <+> plus or <Space> key to promote the selected device type
up the list in the boot order.
b. Use the minus (-) key to move the device type down the list.
3. To change the boot order of the hard drives installed, scroll to "IDE Hard
Drive" and press <Enter>.
A hard drive (HD) boot list similar to the one below appears on screen
depending on the hard drives installed. The NetServer attempts to boot the
NOS on the first hard disk drive found in this list. If no NOS is found, the
NetServer tries the next hard drive in the list until a NOS is found.
Configuring the HP NetServer
[Legacy Floppy]
[HP 8.4GB]
[HP CD-112]
[Disabled]
51