HP D6030A - NetServer - E50 Installation Manual page 31

Chapter 4
7. Unplug the power and SCSI or IDE cables to any hard disk drives already
in the cage.
CAUTION Install and remove connectors carefully and avoid displacing
any pins.
Hard Disk
Drive Cage
Figure 4-2. Captive Screws Holding the Hard Disk Drive Cage
8. Remove the mass storage cage. See Figure 4-3.
CAUTION
All mounting screws that thread into the hard disk drive must
be #6-32 and not exceed ¼-inch in length. Longer screws may
cause internal damage to the mass storage device. Damage
caused by using incorrect mounting screws may not be
covered by the HP warranty.
Installing Mass Storage Devices
Top of HP NetServer
Side View
Front of
HP NetServer
Screws (3)
25