HP D6030A - NetServer - E50 Installation Manual page 81

Appendix A
Table A-4. Hardware Specifications
Specification Characteristics
Intel Pentium III processors: supported speeds 533 and
Processors
600MHz; 512KB level 2 cache on processor.
Chipset VIA Apollo Pro133 AGP2x set with 133Mhz front side bus
speed support
Supports up to three SDRAM DIMMs for a maximum total
Memory
of
Supported DIMM types:
64MB, 128MB or 256MB registered; 72 bits wide, ECC
single-bit correcting, multi-bit detecting.
AGP slot (rev. 1.0 compliant) with bundled ATI Rage IIc
Video
AGP (Accelerated Graphics Port) video board with 4MB
SDRAM; supporting up to 1600x1200, 65K colors.
The IRQ jumper (enable/disable) on the AGP board is set to
disable by default.
HP Ultra/wide SCSI single channel PCI controller board;
SCSI
40MB/s transfer rate, two 68-pin connectors and one 50-pin
connector.
IDE Ultra DMA/66 E-IDE dual channel embedded controller.
PCI Bus 32-bit, 33 MHz speed. PCI rev. 2.2 compliant.
I/O Two Serial ports
One bi-directional parallel port
with ECP/EPP high-speed support;
A PS/2 style mouse and keyboard connectors.
Bundled HP CD-ROM drive; IDE interface; 40x speed.
CD-ROM
(3 x 256 MB).
768 MB
Specifications
75