Factory Default Jumper Settings - HP D6030A - NetServer - E50 Installation Manual

Appendix A

Factory Default Jumper Settings

This topic provides the factory default settings for jumpers and the location of
connectors on the system board not called out in Figure A-1. The factory jumper
settings should not be altered or it may cause damage to the system board or
components on the board. See Table A-6 and Figure A-2.
CAUTION Do not alter the restricted (factory) settings or damage may
result due to capability issues. HP reserves the right to charge
for resolving problems caused by unauthorized or untrained
non-HP personnel who have made changes to restricted
jumper settings and unsupported features.
Table A-6. Jumper and Connector Restrictions
Item Supported/
No. Restricted
1 Not Supported
2 Supported
3 Not Supported
4 Restricted
5 Restricted
6 Not Supported
7 Not Supported
8 Not Supported
9 Not Supported
10 Not Supported
11 Supported
12 Supported
13 Not supported
Description
CPU Fan Power connector (CPU_FAN)
This connector is used for the chassis fan (PWR_FAN)
Keyboard Power Up Setting jumper (KBPWR)
Default = Disabled
I/O Voltage setting jumper (VIO)
Factory set = Normal
Voltage Regulator Output Setting jumper (VCORE)
Factory set = Normal
CPU Thermal Sensor connector (JTCPU)
Wake-On-LAN connector (WOL_CON)
Chassis Intrusion Alarm connector (Chasis)
Power Supply Thermal Sensor connector (JTPWR)
System Management Bus connector (SMB)
Panel connector – This header provides the connections
for the power switch and power indicator on the front
panel
This connector provides the IDE LED activity light
connection (IDELED) on the front panel
Infrared Port Module connector (IR)
Specifications
77