Installing Additional Dimms - HP D6030A - NetServer - E50 Installation Manual

Chapter 5
Use only HP DIMMs, which are available in the following DIMM sizes:
64, 128, and 256 MB.
DIMM sizes may be mixed on the system board.
DIMMs may be installed in any combination in any slot.
However, HP recommends starting at slot 0 (or A) and filling the slots in
sequential order: 0 (or A), 1 (or B), etc.
NOTE
Some NOSs (Windows 2000, NetWare 5.1) require at least 128
MB or more of memory to install.

Installing Additional DIMMs

1. If the NetServer is already installed and working, gracefully power down
the NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
2. Disconnect the power cables and any external cables connected to the
NetServer.
If necessary, label each one to expedite re-assembly.
3. Remove the cover and turn in the NetServer feet (so that the NetServer will
lie flat on its side).
Refer to Chapter 3, "Opening and Closing the HP NetServer."
WARNING
The power supply will continue to provide standby current to
the HP NetServer until the power cable is disconnected.
4. Lay the NetServer on its side (components showing).
CAUTION
The DIMMs are sensitive to static electricity and can be easily
damaged by improper handling. Do the following when
handling the accessory kit:
Leave the memory module in the anti-static container until
you are ready to install it.
Use an anti-static wrist-strap and a grounding mat.
Before you remove a memory module from the anti-static
container, touch a grounded, unpainted metal surface on the
HP NetServer to discharge static electricity.
30
Installing Additional Memory