Updating Bios - HP D6030A - NetServer - E50 Installation Manual

Chapter 8
you to set the base address and block size of the non-PnP board that uses
any memory segment with in the C800 and DFFF address range. If you are
using this type of board and you are not using an ISA Configuration Utility
(ICU) to specify its address range, you must select a base address from the
six available options, [C800], [CC00], [D000], [D400], [D800], and
[DC00].
16. Press + or – to change the value and then select a base address from the six
available options listed above.
The ISA MEM Block SIZE field appears for selecting the block size. If
you have more than one non-PnP ISA board in your NetServer that
requires the use of this address range, you can increase the block size to
8K, 16K, 32K, or 64K. If you are using an ISA Configuration Utility (ICU)
to accomplish this task, leave the ISA MEM Block Base at its default
setting of [No/ICU].
17. Select the appropriate block size and then press ESC twice to exit these
submenus.
18. When all the necessary IRQs and other resources are reserved, press the
[F10] function key to save and exit.
A dialog appears asking you to confirm your decision.
19. Choose "Yes" and press Enter.
The HP NetServer reboots.
NOTE If you change your mind and want to exit the Setup Utility
without making the changes you have selected, press ESC
once or twice to return to the Setup Utility menu. Use the right
arrow key to select the Exit menu. Use the down arrow key to
highlight Exit Discarding Changes. In the Confirmation
dialog box, use the right arrow key to highlight Yes. Press
Enter to answer "Yes" to the question.

Updating BIOS

The flash utility used to update the BIOS is provided on the HP Startup CD-ROM.
Instructions are provided on the CD about creating the system diskette, copying
the flash utility, and updating the BIOS. Refer to the HP web site for BIOS
updates.
56
Configuring the HP NetServer