Installing Hard Disk Drives - HP D6030A - NetServer - E50 Installation Manual

Chapter 4

Installing Hard Disk Drives

The installation of the hard disk drives is the same for both IDE or SCSI drives.
The IDE drives require setting jumpers on the drives for the master and slave
drive selection before installing the drives. The SCSI drives are set up electrically
in the SCSI configuration utility.
1. If the NetServer is already installed and working, gracefully power down
the NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
2. Disconnect the power cable and any external cables connected to the
NetServer.
If necessary, label them to expedite re-assembly.
3. Remove the cover and turn in the NetServer feet (so that the NetServer will
lie flat on its side).
Refer to Chapter 3, "Opening and Closing the HP NetServer."
4. Lay the NetServer on its side (components showing).
5. Unsnap the air duct and move it out of the way. See Figure 4-1.
6. Loosen three captive screws on the mass storage cage. See Figure 4-2.
24
Figure 4-1. Moving the Air Duct
Installing Mass Storage Devices