Changing The Admin Password And User Id; Configuring The Ip And Fibre Channel Address - HP StorageWorks 2/16 - SAN Switch Installation Manual

Managing the SAN Switch 2/16

Changing the Admin Password and User ID

Use these steps to change the Admin user ID and password.
Note:
to change the admin user ID and system password.
1. Log into the switch as the admin user.
2. At the command line enter the following command:
3. At the New Username prompt, enter a new name for the admin user. You
4. At the Old Password prompt, enter the old password.
5. At the New Password prompt, enter the new password. The new password
6. At the New Password prompt, enter the new password exactly as entered to
7. Press Enter to commit the configuration to the firmware.

Configuring the IP and Fibre Channel Address

The SAN Switch 2/16 is shipped with a default IP address of 10.77.77.77.
Use these steps to change the default IP Address and configure the Fibre Channel
IP address of the switch.
1. Log in to the switch as the admin user.
2. At the command line enter the following command:
3. At the Ethernet IP Address prompt, enter the new IP address for the
70
For security reasons, the first time you log into the Fabric OS you are requested
Password admin
An interactive session is opened and you are prompted for configuration
values.
can change the name of the admin user without changing the password. Press
Enter to leave the name as is.
must be from 8 to 40 characters in length.
the previous prompt.
ipAddrSet
An interactive session is opened and you are prompted for configuration
values. Press the Enter to skip over a prompt and leave the parameter value as
is.
Ethernet port on the switch. Press the Enter to continue.
hp StorageWorks SAN Switch 2/16 Installation Guide