Configuring The Ip And Fibre Channel Address - HP StorageWorks 2/32 - SAN Switch Installation Manual

2. At the command line, enter the following command:
3. At the New username prompt, enter a new name for the admin user. You
4. At the Old Password prompt, enter the old password.
5. At the New password prompt, enter the new password. The new password
6. At the New password prompt, enter the new password exactly as entered to
7. Press Enter to commit the configuration to the firmware.
Note:
without knowing the switch password.

Configuring the IP and Fibre Channel Address

The SAN Switch 2/32 is shipped with a default IP address of 10.77.77.77.
Use these steps to change the default IP Address and configure the Fibre Channel
IP address of the switch.
1. Login to the switch as the admin user.
2. At the command line enter the following command:
3. At the Ethernet IP Address prompt, enter the new IP address for the
4. At the Ethernet Subnetmask prompt, enter the address of the
5. At the Fibre Channel IP address prompt, enter the Fibre Channel
SAN Switch 2/32 Installation Guide
Password admin
An interactive session is opened and you are prompted for configuration
values.
can change the name of the admin user without changing the password. Press
Enter to leave the name as is.
must be from 8 to 40 characters in length.
the previous prompt.
Save your passwords in a safe place. It is nearly impossible to access a switch
ipAddrSet
An interactive session is opened and you are prompted for configuration
values. Press Enter to skip over a prompt and leave the parameter value as is.
Ethernet port on the switch. Press Enter.
subnetmask, if applicable. Press Enter.
IP address for the switch. Press Enter.
Managing the SAN Switch 2/32
71