Brocade Communications Systems SN3000B Command Reference Manual page 721

To display the VLAN tagging configuration only:
To display an FCIP Tunnel on a Brocade FX8-24 with and without IPSec information (In the following
examples, IPSec is in legacy mode):
Fabric OS Command Reference
53-1001764-01
Interface IPv6 Address
--------------------------------------------------------
0 20::2:10
Inband management configuration:
Arp configuration:
IP Address Mac Address
------------------------------
Iproute Configuration:
IP Address Mask
------------------------------------------------------
192.168.42.0 255.255.255.0
IPv6ddress Len
-------------------------------------------------------
20:42:: 64
Inband Management route configuration:
Fciptunnel configuration:
Vlantag configuration:
-------------------------
Interface Address
Destination Address
------------------------------------------------------
192.168.2.10
192.168.2.10
switch:admin> portcfgshow vlantag ge2
Port: ge2
Vlantag configuration:
-------------------------
Interface Address
Destination Address
---------------------------------------------------
192.168.2.20
192.168.2.21
switch:admin> portcfgshow fciptunnel 1/12 -ipsec
-------------------------------------------
Tunnel ID: 1/12
Tunnel Description:
Compression: Off
Fastwrite: Off
Tape Acceleration: Off
Gateway
192.168.2.250
Gateway
20::2:250
VlanId
0.0.0.0
192.168.2.21
VlanId
200
0.0.0.0
300
192.168.2.10
portCfgShow
Len MTU
64 1500
Metric
0
Metric
0
L2CoS
200 5
300 5
L2CoS
5
5
2
695