Trunkdebug - Brocade Communications Systems SN3000B Command Reference Manual

trunkDebug

Debugs a trunk link failure.
SYNOPSIS
trunkdebug port1 port2
DESCRIPTION
Use this command to debug a trunk link failure. This command reports one of the following messages,
based on the trunking properties of the two specified ports:
•
•
•
•
•
•
•
•
•
•
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
port1
port2
EXAMPLES
To debug a trunk connection:
SEE ALSO
portCfgTrunkPort, switchCfgTrunk,
Fabric OS Command Reference
53-1001764-01
Switch does not support trunking
Trunking license required
port port_id is not E_Port
port port_id trunking disabled
port port_id speed is not 2G, 4G or 8G
port port_id and port port_id are not in same port group
port port_id and port port_id connect to different switches
port port_id and port port_id connect to the switch WWN
port port_id is not a trunking port due to: E_Port being disabled, or trunking might be disabled at
remote port
port port_id and port port_id cannot trunk, please check link length to make sure difference is less
than 400 m
Specify the port index number of port 1. Use the switchShow command to view
the index numbers for a port. This operand is required.
Specify the port index number of port 2. Use the switchShow command to view
the index numbers for a port. This operand is required.
switch:admin> trunkdebug 43 44
Switch does not support trunking
switch:admin> trunkdebug 62 63
port 62 and 63 are trunked together
trunkShow
2
trunkDebug
1035