Brocade Communications Systems SN3000B Command Reference Manual page 674

22
portCfgEXPort
-m port mode
-i mode
EXAMPLES
To set the fabric ID of port 2/1 to 5 and the port ID format to core:
To configure port 2/0 to be an EX_Port and set the fabric ID to 4:
To disable fabric parameter negotiation on port 2/0 of an EX_Port:
To enable IDID on port 2:
To display EX_Port settings configured for Mi10K connectivity:
648
Specifies the port mode. The -m option enforces the same port mode for all the
ports connected to the same edge fabric. If this option is selected, the port mode
is compared against the online ports. If the modes are different, an error message
is posted, and the command fails. Valid values are as follows:
0
Brocade Native mode.
1
McDATA Open Fabric mode.
2
McDATA Fabric mode.
3
MCDATA fabric legacy mode.
5
Brocade Network OS fabric mode.
Enables or disables Insistent Domain Id (IDID) for the specified EX_Port. Specify
1 to enable IDID, specify 2 to disable IDID. This command must be issued from a
McDATA edge switch attached to a single or dual FCR configuration.
switch:admin> portcfgexport 2/1 -f 5 -p 1
switch:admin> portcfgexport 2/0 -a 1 -f 4
switch:admin> portcfgexport 2/0 -t 2
switch:admin> portcfgexport 2 -i 1
switch:admin> portcfgexport 10
Port 10 info
Admin:
State:
Pid format:
Operate mode:
Edge Fabric ID:
Preferred Domain ID:
Front WWN:
Fabric Parameters:
R_A_TOV:
E_D_TOV:
Authentication Type: None
DH Group: N/A
Hash Algorithm: N/A
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A
enabled
OK
Not Applicable
Open
70
239 mode
50:00:51:e3:76:0e:4e:46
Auto Negotiate
Not Applicable
Not Applicable
Fabric OS Command Reference
53-1001764-01