Ficoncfg - Brocade Communications Systems SN3000B Command Reference Manual

22

ficonCfg

ficonCfg
Configures the specified FICON database.
SYNOPSIS
ficoncfg --set database port
ficoncfg --reset database
ficoncfg --help
DESCRIPTION
Use this command to configure a FICON database on a specified port. Refer to ficonShow for a
description of the database content.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
port
--set
--reset
database
EXAMPLES
To set the LIRR database on a port using a decimal index number:
To reset the LIRR
To set the LIRR database using a hexadecimal port number:
SEE ALSO
ficonHelp,
338
Specifies the port to be configured. You can specify the port by its port index
number or by a hexadecimal number. Use switchShow for a listing of valid port
index numbers.
Sets the configuration entry.
Resets the configuration entry to its default value.
Specifies the name of the FICON database. The only database currently
supported is the following:
LIRR
Devices registered to receive link incident reports.
switch:user> ficoncfg --set LIRR 27
switch:user> ficoncfg --reset LIRR
switch:user> ficoncfg --set LIRR 0x1b
switch:user> ficoncfg --show LIRR
The Local LIRR database has 0 entries.
Current LIRR device port number: 27 (0x1b)
ficonShow
Fabric OS Command Reference
53-1001764-01