Brocade Communications Systems SN3000B Command Reference Manual page 33

--remove server
--move server option
--authspec "aaa1[;aaa2" [-backup] [-nologout]
Fabric OS Command Reference
53-1001764-01
Valid protocols are one of the following:
pap
Password Authentication Protocol
chap
Challenge-Handshake Authentication Protocol
peap-mschapv2
Protected Extensible Authentication Protocol (requires Fabric OS v5.3.0 or
later)
Removes the specified server from the configuration. The server must match one
of the IP addresses or the names shown in the current configuration. The
following operand is required:
-conf radius | ldap
Specifies the server configuration as either RADIUS or LDAP. If the server is
enabled, the command does not allow the last server to be removed from the
configuration list. RADIUS or LDAP must first be disabled before the last server of
the specified type may be removed.
Moves the specified server from the current position in a RADIUS or LDAP
configuration list to the specified position. If the specified position is the same as
the current position, no change takes place. Valid options include the following:
-conf radius | ldap
Specifies the server configuration as either RADIUS or LDAP. This operand is
required.
to_position
Specifies the new position for the server. The value for to_position is an integer,
and must be within the range of server positions in the current configuration. Use
the --show option to determine current server positions. This operand is required.
Replaces the configuration with the specified AAA service. Each service can be
specified only once in the list, for example, "radius; local; radius" is invalid. No edit
option is provided. The --authspec option takes as an argument a
semicolon-separated list of AAA services. Services must be enclosed in double
quotation marks.
The following AAA services and service pairs are valid:
"local"
Default setting. Authenticates the user against the local database only. If the
password does not match or the user is not defined, the login fails.
"radius"
When "radius" is specified, the first RADIUS server is contacted. If the RADIUS
server is not reachable, the next RADIUS server is contacted. If the authentication
fails, the authentication process does not check for the next server in the
sequence.
"ldap"
When "ldap" is specified, the first Active directory (AD) server is contacted. If the
AD server is not reachable, the next AD server is contacted. If the authentication
fails, the authentication process does not check for the next server in the
sequence.
2
aaaConfig
7