Brocade Communications Systems SN3000B Command Reference Manual page 175

Zoning Operation Parameters
The following zoning operation parameter can be modified.
Disable NodeName Zone Checking
RSCN Transmission Mode
The RSCN transmission modes and values are as follows:
End-device RSCN Transmission Mode
Domain RSCN to End-device
Arbitrated Loop Parameters
Arbitrated Loop Parameter and their values are as follows:
Send FAN frames?
Enable CLOSE on OPEN received?
Always send RSCN?
System Services Settings
The values for the System Services settings are as follows:
Disable RLS probing
Fabric OS Command Reference
53-1001764-01
Specify 1 to disable using node WWN when specifying nodes in the zone
database. Specify 0 to enable using node WWN when specifying nodes in the
zone data. The default value is 0. This value must be set to 1 for interpretability.
Values are as follows:
0
RSCN only contains single PID
1
RSCN contains multiple PIDs (Default)
2
Fabric addresses RSCN
Values are as follows:
0
Disabled. No domain RSCN is sent to the end-device for the switch IP address or
name change.
1
Enabled. Domain RSCN is sent to the end-device for the switch IP address or
name change.
Specifies that fabric address notification (FAN) frames be sent to public loop
devices to notify them of their node ID and address. When set to 1, frames are
sent; when set to 0, frames are not sent. The default value is 1.
If this is set, a CLS is returned immediately to an OPN if no buffers are available.
This is required for TachLite. The valid range is 0 to 4. The default value is 0.
Following the completion of loop initialization, a remote state change notification
(RSCN) is issued when FL_Ports detect the presence of new devices or the
absence of preexisting devices. When set to 1, an RSCN is issued upon
completion of loop initialization, regardless of the presence or absence of new or
preexisting devices. When set to 0, an RSCN is not sent (default).
Enables or disables the read link status (RLS) probing. Performed by the FCP
daemon, RLS probing reads the link error block from the device. This extended
link services command is defined by the FC standards. Refer to the FC standards
for information. RLS probing is enabled by default, meaning "Disable RLS
probing" is "off". "on" disables RLS probing.
2
configure
149