Cloning Zones; Deleting Zones - Brocade Communications Systems SN3000B Administrator's Manual

4. Click Rename.
5. In the Rename a Zone dialog box, enter a new zone name and click OK. The zone is renamed in
6. Select Zoning Actions > Save Config to save the configuration changes.

Cloning zones

To perform clone operations for zoning, the EGM license must be installed on the switch;
otherwise, access to this feature is denied and an error message displays.
The EGM license is required only for 8 Gbps platforms, such as the following:
•
•
•
•
•
For non-8 Gbps platforms, all functionalities are available without EGM license.
To clone a zone configuration, perform the following steps.
1. Open the Zone Admin window as described in
2. Click the Zone tab.
3. Select the zone you want to clone from the Name list.
4. Click Clone
5. In the Clone an Existing Zone dialog box, enter a name for the copied zone.
6. Click OK. The selected zone is copied from the Zone Admin buffer.
7.

Deleting zones

For information on enabling the configuration, refer to
To delete a zone, perform the following steps.
1. Open the Zone Admin window as described in
2. Click the Zone tab.
3. Select the zone you want to delete from the Name menu and click Delete.
4. On the confirmation dialog box, click Yes.
5. Select Zoning Actions > Save Config to save the configuration changes.
Web Tools Adminstrator's Guide
53-1002152-01
the Zone Admin buffer.
Brocade Encryption Switch
Brocade 300, 5300, and 5100 switches
Brocade VA-40FC
Brocade 8000
Brocade 7800
Select Zoning Actions > Save Config to save the configuration changes. Because no changes
were made to the effective configuration, you do not need to enable the configuration.
The selected zone is deleted from the Zone Admin buffer. At this point, you can either save your
changes or save and enable your changes.
Zoning management
"Opening the Zone Admin window"
"Enabling zone configurations"
"Opening the Zone Admin window"
9
on page 118.
on page 131.
on page 118.
127