Creating The Scsi Vs. Ip Traffic Graph; Creating Scsi Command Graphs - Brocade Communications Systems SN3000B Administrator's Manual

8
Advanced performance monitoring graphs
5. Select a destination ID from the Port or Sid/Did Selection List, and click Add Did.
6. Click OK.
7.
8. When you close a graph, a dialog box asks if you want to save the monitor.

Creating the SCSI vs. IP Traffic graph

The SCSI vs. IP Traffic graph displays the SCSI versus IP traffic for selected ports. For Brocade
8510-8, Brocade 8510-4, and Brocade DCX and Brocade DCX 4S enterprise-class platforms, the
slot and port name are identified in the graph.
In a trunk group, the SCSI vs. IP Traffic graph displays only the master port and not the slave ports.
To create a SCSI vs. IP Traffic graph, perform the following steps.
1. Open the Performance Monitoring window.
2. Select Performance Graphs > Advanced Monitoring > SCSI vs. IP Traffic.
3. Double-click the domain to expand the slot/port list.
4. Click the port you want to monitor in the graph in the Port Selection List. Use Shift+click and
5. Click Add to move the selected ports to the Selected Ports list.
6. Optional: Click ADD ALL Ports to add all of the ports in the Port Selection List to the Selected
7.
8. Click Apply in the SCSI vs. IP Traffic Setup dialog box.

Creating SCSI command graphs

This graph displays the total number of read or write (or both) commands on a given port or to a
specific LUN on a given port.
112
You can also enter a destination ID in the Enter/drag DID number field.
If you selected multiple EE monitors, SIDs, or PIDs, a confirmation dialog box displays,
reminding you that one graph is opened for each selection.
Click Yes to display the graphs.
If you click OK, the monitor is saved, and persists if the switch is restarted.
The SCSI vs. IP Traffic Setup dialog box displays. This dialog box is similar to that shown in
Figure 22 on page 110.
NOTE
For Brocade 8510-8, Brocade 8510-4, and Brocade DCX and Brocade DCX 4S enterprise-class
platforms, click the plus (+) signs to expand the ports under each slot, as shown in
Ctrl+click to select multiple ports.
Ports list.
Optional: Click Search to open the Search Port Selection List dialog box, from which you can
search for all E_Ports, all F_Ports, or all port names with a defined string. Select the ports you
want to add and click Search in the Search Port Selection List dialog box.
Only the selected ports are displayed in the SCSI vs. IP traffic graph.
Figure
Web Tools Adminstrator's Guide
53-1002152-01
22.