Installing Processor Heatsink(S); Figure 10. Installing Processor - Remove The Cover; Figure 11. Installing Processor - Close The Load Plate; Figure 12. Installing Processor - Latch The Locking Lever - Intel MFS2600KI User Manual

5. Close the Load Plate. Carefully lower the load plate over the processor.
6. Latch the Locking Lever. Push down on the locking lever on the CLOSE 1st side (see letter A).
Slide the tip of the lever under the notch in the load plate (see letter B). Make sure the load
plate tab engages under the socket lever when fully closed. Repeat the steps to latch the locking
lever on the other side (see letter C). Latch the levers in the order as shown.

Installing Processor Heatsink(s)

1. Remove the protective film on the TIM if present (see letter A).
2. Align heatsink fins to the front and back of the chassis for correct airflow. Airflow goes from
front-to-back of chassis (see letter B).
Each heatsink has four captive fasteners and should be tightened in a diagonal manner using the
following procedure:
3. Using a #2 Phillips* screwdriver, start with screw 1 and engage screw threads by giving it two
rotations and stop (see letter C). (Do not fully tighten.)
4. Proceed to screw 2 and engage screw threads by giving it two rotations and stop (see letter D).
Similarly, engage screws 3 and 4.
®
Intel Compute Module MFS2600KI User Guide
Figure 10. Installing Processor – Remove the Cover
Figure 11. Installing Processor – Close the Load Plate
Figure 12. Installing Processor – Latch the Locking Lever
Hardware Installations and Upgrades
13