Table of Contents
Advertisement
Hardware Installations and Upgrades
Installing a Compute Module into the Chassis
To install a compute module into the chassis, follow these steps:
1. Observe the safety and ESD information at the beginning of this manual and in the
appendices.
2. If you have not done so already, install any necessary options, such as processors, memory,
hard drives and expansion cards in the compute module.
NOTE
The top cover is a required component of the compute module; do not attempt to insert a compute
module into a chassis without a top cover installed.
3. Make sure the retention levers on the compute module are in the open position.
4. Insert the compute module into an open slot in the chassis and slide it in until it stops.
5. Close the retention lever handles on the front of the compute module.
Removing or Installing the Top Cover
Removing the Top Cover
To remove the top cover, follow these steps:
1. Observe the safety and ESD information at the beginning of this manual and in the
appendices.
2. If the compute module is installed in a chassis, remove it. For instructions, see "Removing
a Compute Module from the Chassis" on page 20.
3. Carefully lay the compute module down on a flat, non-conductive surface, with the cover
side up.
4. Press the top cover release button (see letter A in Figure 6) and slide the top cover back,
away from the compute module bezel (see letter B in Figure 6).
5. Lift the top cover up and off the compute module (see letter B in Figure 6).
Caution: Always install the top cover before installing the compute module into a chassis.
8
®
Intel
Compute Module MFS2600KI User Guide
Advertisement
Table of Contents
