Egress Rate Limiting; Figure 80. At-Gs950/8 Egress Rate Limiting Page - Allied Telesis AT-GS950/8 User Manual

Chapter 14: Storm Control

Egress Rate Limiting

212
This procedure explains how to set Bandwidth levels and Status for
Egress Rate Limiting on each port of the AT-GS950/8 switch.
To change the settings of the egress rate limiting feature, perform the
following procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
2. From the Bridge folder, select Bandwidth Control.
The Bandwidth Control folder expands.
3. From the Bandwidth Control folder, select Egress Rate Filtering.
The AT-GS950/8 Egress Rate Limiting page is displayed. See
Figure 80.

Figure 80. AT-GS950/8 Egress Rate Limiting Page

To set the Bandwidth field, enter a number in the range of 1 to 15625.
You can select the ALL row to set all of the ports to the same setting.
Note
See "Egress Rate Limiting" on page 207 for calculating the
bandwidth limit set by the Bandwidth field.
4. To enable or disable egress rate filter, select Enable or Disable from
the Status pull-down menu next to the port that you want to change.
You can select the ALL row to set all of the ports to the same setting.
5. Click Apply.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.