System Information - Allied Telesis AT-GS950/8 User Manual

Chapter 19: LLDP
System
Information
260
3. From the LLDP parameter, select one of the following radio button
choices:
Enable - The LLDP feature is active.
Note
The LLDP feature is not dependent on the DHCP feature. Therefore
the DHCP feature can be either Enabled or Disabled without
affecting LLDP.
Disable - The LLDP feature is inactive.
4. Click the Apply button just to the right of the Enable or Disable radio
buttons.
The LLDP setting that you have selected is now active.
5. Just below the Enable or Disable radio buttons, you may adjust the
following parameters as required:
Message TX Hold Multiplier - Sets the hold multiplier value. The
hold time multiplier is multiplied by the transmit interval to give the
Time To Live (TTL) that the switch advertises to the neighbors.
The range is 1 - 10.
Message TX Interval - Sets the transmit interval, which is the
interval between regular transmissions of LLDP advertisements.
The range is 1 - 10 seconds.
LLDP Reinit Delay - Sets the reinitialization delay, which is the
number of seconds that must elapse after LLDP is disabled on a
port before it can be reinitialized. The range is 1 - 10 seconds.
LLDP TX Delay - Sets the value of the transmission delay timer,
which is the minimum time interval between transmissions of LLDP
advertisements due to a change in LLDP local information. The
range is 1 - 8192 seconds.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Refer to Figure 93 on page 259 for the following LLDP System Information
parameters.
Chassis ID Subtype - This parameter describes the Chassis ID
subtype which is "macAddress". You cannot change this
parameter.
Chassis ID - This parameter is the MAC Address of the switch.
You cannot change this parameter.
System Name - This parameter is the System Name of the switch.