Port Mirroring Configuration; Figure 23. At-Gs950/8 Mirroring Page - Allied Telesis AT-GS950/8 User Manual

Port Mirroring Configuration

To configure Port Mirroring, perform the following procedure:
1. Select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder, select Mirroring.
The Mirroring Page is displayed. See Figure 23.

Figure 23. AT-GS950/8 Mirroring Page

3. Click the pull-down menu on the Status field and select one of the
following choices:
Enable - This parameter activates the Port Mirroring feature and
the rest of the configuration parameters become active on the
page.
Disable - This parameter de-activates the Port Mirroring feature
and the rest of the configuration parameters become inactive on
the page.
4. Click Mirroring Port and from the pull-down menu, select the port.
5. For the source port, select the port(s) whose ingress, egress, or both
ingress and egress traffic you want to monitor.
A check in a box indicates the Ingress or Egress traffic for a port has
been selected.
6. Click Apply on the right-hand side of the page.
The Port Mirroring configuration is implemented immediately on the
AT-GS950/8 switch.
You can connect a data analyzer to the mirroring port to monitor the
Ethernet traffic on the source port(s).
AT-GS950/8 Web Interface User Guide
69