Power switch assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the cable from the PB/LED system board connector.
NOTE:
5.
From the inside of the computer, press the tab on the left side of the power switch (1), and then push
the power switch out of the front of the chassis.
54
Chapter 4 Removal and replacement procedures: Microtower
(Access panel on page
(Front bezel on page
System board layout may vary.
(Preparation for disassembly on page
24).
25).
23).