Lexmark C750 Service Manual page 74

5060-00x
User primary
message
58 Too Many Disks
Installed
58 Too Many Flash
Options
59 Incompatible
Output Bin x
59 Incompatible Tray
x
61 Defective Disk
62 Disk Full
63 Unformatted Disk
2-40
Service Manual
User secondary
Explanation
message
This message is displayed when too many disks are
installed.
Note: Some configurations of different output options
require the installation of one option before the other.
This message is displayed when too many Flash Options
are installed. Verify the maximum number of flash memory
options which may be installed.
Note: Press Go to clear the message. The extra flash
memory options are ignored.
These messages are displayed when the user installs an
incompatible option.
The following options may be incompatible for use on one or
more 50xx models:
• Output Bin x (x=1, 2 or 3)
• Tray x (x=2,3,4 or 5)
• Duplex
The user is required to remove the incompatible option and
press Go to clear the message.
Note: If the user installed the incompatible option to satisfy a
Check Option Connections/Reattach Option attendance
condition, the user must reinstall an associated compatible
option or hot unplug the option.
This message is displayed when the printer detects a
defective disk. This error may occur at power on, or during
disk format and write operations.
Press Go to clear the message.
The disk is marked as defective and normal printer
operation continues.
Disk operations are not allowed with a defective disk and the
Format Disk menu item is not shown.
This message is displayed when there is not enough free
space on the disk to hold the data that have been requested
to be written to the disk. This message is displayed for both
resource collection and PostScript emulation when the disk
is full.
The following actions can be taken, however this deletes all
downloaded Fonts and Macros not written to disk.
• Press Go to clear the message and continue processing
• Press Menu to access the Busy/Waiting Menu
The following functions may be available:
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
This message is displayed when the printer detects an
unformatted disk at POST.
Press Go to clear the message.
The disk is marked as bad and normal operation continues,
however disk operation is not allowed until the disk is
formatted.
the print job