Lexmark C750 Service Manual page 63

User primary User secondary
message message
230 Paper Jam Clear Leave Job in Finisher
Paper Path area 5
24x Paper Jam Clear Leave Job in Finisher
Paper Path area 5
250 Paper Jam Clear Leave Job in Finisher
Paper Path area 5
251 Paper Jam Clear Leave Job in Finisher
Paper Path area 5
271 Paper Jam Clear Leave Job in Finisher
Paper Path area 5
Explanation
Primary: Paper has most likely jammed in the duplex option.
Remove the duplex tray to access the jam.
Secondary: If sheets have been accumulated to be stapled
when the jam is detected, the printer alternately flashes the
primary and secondary messages indicating the
accumulated sheets should not be removed during jam
clearing.
Note: When the secondary message is displayed, if the
accumulated sheets are removed the printer will not reprint
these sheets. Also if the print job is completed, the portion of
the job printed after the jam will not be stapled.
Primary: This paper jam message can apply to both the
500-sheet option tray and HCIT option. Tray x (x=2 through
4). Try opening tray x, if the tray is difficult to remove then
you may need to remove the tray above or below tray x to
remove the jammed media.
Secondary: If sheets have been accumulated to be stapled
when the jam is detected, the printer alternately flashes the
primary and secondary messages indicating the
accumulated sheets should not be removed during jam
clearing.
Note: When the secondary message is displayed, if the
accumulated sheets are removed the printer will not reprint
these sheets. Also if the print job is completed, the portion of
the job printed after the jam will not be stapled.
Primary: Paper is jammed in the MPF.
Secondary: If sheets have been accumulated to be stapled
when the jam is detected, the printer alternately flashes the
primary and secondary messages indicating the
accumulated sheets should not be removed during jam
clearing.
Note: When the secondary message is displayed, if the
accumulated sheets are removed the printer will not reprint
these sheets. Also if the print job is completed, the portion of
the job printed after the jam will not be stapled.
Primary: The paper has jammed in the paper path near the
MPF due to an in-line transparency sensor mismatch.
Secondary: If sheets have been accumulated to be stapled
when the jam is detected, the printer alternately flashes the
primary and secondary messages indicating the
accumulated sheets should not be removed during jam
clearing.
Note: When the secondary message is displayed, if the
accumulated sheets are removed the printer will not reprint
these sheets. Also if the print job is completed, the portion of
the job printed after the jam will not be stapled.
Primary: Paper has jammed at output bin 1. Open the door
of bin 1 to access the jammed media.
Secondary: If sheets have been accumulated to be stapled
when the jam is detected, the printer alternately flashes the
primary and secondary messages indicating the
accumulated sheets should not be removed during jam
clearing.
Note: When the secondary message is displayed, if the
accumulated sheets are removed the printer will not reprint
these sheets. Also if the print job is completed, the portion of
the job printed after the jam will not be stapled.
5060-00x
2-29
Diagnostic information