Lexmark C750 Service Manual page 66

5060-00x
User primary
message
Reattach Output Bin x
Reattach Bins x-y
Check Tray x
Connection
Check Duplex
Connection
Check Finisher
Connection
Close Door
Close Finisher Door
Disk Corrupted
Hole Punch Waste
Full
2-32
Service Manual
User secondary
Explanation
message
These messages are displayed anytime the printer loses
communications with one of the following options:
• Output Bin x (x=1, 2, or 3)
• Bins (x-y=1 through 5)
• Tray x (x=2, 3, 4, or 5)
• Duplex
• Finisher
The specified option could have been removed from the
printer, maybe to clear a paper jam or to uninstall the option
or the option may be still installed but experiencing a
communications problem. The option may not be fully
installed or it may have a hardware failure. The most likely
cause of this message is a failure to reattach the option
when removed to service a printer intervention.
If the option was temporarily removed or not connected
properly, then reattach or reconnect it. When the option is
recognized, the printer automatically clears the attendance
message and continues. Press Go to execute a
configuration change which will tell the printer the option has
been Hot Unplugged removed. In this case it is assumed
that the user wants to continue to operate the printer with
the option removed. If the problem continues, turn the
printer off and back on. If the message continues to be
displayed, turn the printer off, remove the option and call for
service.
This message is displayed when the printer upper front
cover (door) is open.
Close the upper front cover (door).
This message is displayed when the finisher Option top
cover is open. Close the finisher top cover.
This message is displayed when the printer has detected
that there are errors on the hard disk that could not be
corrected. The disk cannot be used until it has been
reformatted.
The following actions can be taken:
• Press Return or Stop to clear the message.
Note: All data will be lost for the following action:
• Press Go to format the disk.
This message is displayed when the Hole Punch Alarm is on
and the code has determined that the hole punch waste box
is full.
The following actions may be taken while this message is
displayed:
• The user may empty the hole punch box and put it back
• Press Go to ignore the message and the job prints
Each time a new job requests hole punch and the box is not
emptied, this message is displayed.
The disk cannot be used without reformatting the
disk.
to clear the message.
without hole punching.