Lexmark C750 Service Manual page 60

5060-00x
2xx
Primary message
code
203 Paper Jam
Clear paper Path
230 Paper Jam
Clear Paper Path
24x Paper Jam
Clear Paper Path
250 Paper Jam
Clear Paper Path
2-26
Service Manual
Secondary message Description
Leave job in Finisher Primary: The media is jammed due to a
transparency sensor mismatch. Open the printer
left door to access the jammed media. If sheets
have been accumulated to be stapled or offset
when the jam is detected, the printer alternately
flashes the primary and secondary messages to
indicate that all accumulated sheets should not be
removed during the jam clearing procedure.
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearing procedure. The printer will not reprint the
removed sheets. Also, if the accumulated sheets
are removed, the portion of the job printed after the
jam will not be stapled.
Leave Job in Finisher Primary: The media is most likely jammed in the
duplex option, remove the duplex tray to access the
jam area. If sheets have been accumulated to be
stapled or offset when the jam occurred, the printer
alternately flashes the primary and secondary
messages to indicate that all accumulated sheets
not be removed during the jam clearing procedure.
If the problem persists, go to
page
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearing procedure as the printer will not reprint the
removed sheets. Also, if the accumulated sheets
are removed, the portion of the job printed after the
jam will not be stapled.
Leave Job in Finisher Primary: Media is jammed around Tray x (Tray x=2
through 4) and applies to both a 500 Tray and HCIT
tray. Try opening Tray x. If the tray is difficult to
remove then you may need to remove the tray
above or below Tray x to remove the jam. If sheets
have been accumulated to be stapled or offset
when the jam occurred, the printer alternately
flashes the primary and secondary messages to
indicate that all accumulated sheets not be
removed during the jam clearing procedure. If the
problem persists, go to
page
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearing procedure as the printer will not reprint the
removed sheets. Also, if the accumulated sheets
are removed, the portion of the job printed after the
jam will not be stapled.
Leave Job in Finisher Primary: Media is jammed in the MP Feeder. If
sheets have been accumulated to be stapled or
offset when the jam occurred, the printer
alternately flashes the primary and secondary
messages to indicate that all accumulated sheets
not be removed during the jam clearing procedure.
If the problem persists, go to
page
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearing procedure as the printer will not reprint the
removed sheets. Also, if the accumulated sheets
are removed, the portion of the job printed after the
jam will not be stapled.
"230 Paper jam" on
2-76.
"24x Paper jam" on
2-77.
"250 Paper jam" on
2-82.