Lexmark C750 Service Manual page 454

5060-00x
Step 5: Connect the finisher and printer
Push the finisher against the printer, making sure the gap in the front is the same as the gap in the back.
When adjoining the finisher and the printer, make sure that the finisher cable is out of the way of the paper path.
If the cable folds itself between the finisher and the printer, disconnect the cable, twist it one time, and then
reconnect it. This may help the cable bend the other direction.
Finisher alignment quick check
Use this table to make sure all alignments have been made.
Make sure:
1. The printer is secured to the floor.
2. The finisher's height is correct.
The pin should align with the hole in the finisher, and the
finisher should easily dock to the printer without interference or
binding with the pin.
3. The finisher is vertically aligned to the printer.
The finisher's two bumper pads should lightly touch the printer.
4. The finisher's tilt is correct.
The printer and finisher's front covers should be flush together
at top and bottom. If you run your hand across them from side
to side they should feel as if they are one part.
5. The finisher is squarely docked to the printer.
The printer and finisher's top covers should have the same
distance between them at the front and rear when docked.
A-28
Service Manual
To make adjustments, see:
"Step 1: Secure the printer" on appendix
page A-24
"Step 2: Align the pin" on appendix page A-25
"Step 3: Align the bumper pads" on appendix
page A-26
"Step 4: Adjust the tilt" on appendix page A-27
"Step 5: Connect the finisher and printer" on
appendix page A-28