Lexmark C750 Service Manual page 71

User primary User secondary
message message
37 Insufficient Held Jobs May Not
Memory Be Restored
38 Memory Full
39 Complex Page
Explanation
These messages are displayed when the printer has
attempted to print and hold jobs from the disk and found that
some or all of the jobs could not be restored. Each of the
three 57 Configuration Held Jobs messages describe
different conditions under which the restore failed.
• Primary Message: 37 Insufficient Memory. The printer
firmware ran out of memory while attempting to restore
the jobs.
Secondary Message: Held Jobs May Not Be Restored.
• Primary Message: 57 Configuration Change—the printer
firmware could not restore jobs from the disk because
the configuration of the printer has changed.
Secondary Message: Held Jobs May Not Be Restored.
• Primary Message: Held Jobs May Not Be Restored
handles any other conditions where any of the print and
hold jobs could not be restored from the disk.
Note: Some of the print and hold jobs may not be restored.
They remain on the disk but cannot be accessed.
This message is displayed when the printer is processing an
incoming job and there is not enough memory available to
continue processing the job.
The following actions can be taken:
You may want to determine how to make more memory
available to your print job by:
• Deleting fonts, macros and other data in RAM
• Simplify your print job
• Install additional memory
• Press Go to clear the message, however some data may
be lost
• Press Menu to access the Busy/Waiting Menu
The following functions may be available.
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
This message is displayed when a page is too complex to
print.
The following actions can be taken:
• Press Go to clear the message and continue processing
the job, some data loss may occur.
• Try to simply the print job
Press Menu> to access the Busy/Waiting Menu.
The following functions may be available:
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
5060-00x
2-37
Diagnostic information