Calibrating From The Control Panel With Autocal Or Colorcal - EFI KM-C1530 Color Manual

2
2-23 Using AutoCal and ColorCal
9. Follow the directions in the dialog box for placing the Gray Scale strip and the AutoCal
or ColorCal measurement page on the copier glass. Click Continue.
AutoCal
10. Click Apply in the main Calibrator window to implement the new calibration set.
11. Click OK in the Information dialog box.
This completes the calibration process.

Calibrating from the Control Panel with AutoCal or ColorCal

If an Administrator password has been set, you will need it to perform calibration
from the Control Panel. For instructions on using the Fiery X3e Control Panel, see the
Configuration
It is also possible to remove calibration measurements from the Fiery X3e. In general,
it is not necessary, because any new calibration replaces the existing one if the same
calibration set is selected.
T A C C
O USE UTO AL OR OLOR
1. Make sure the information screen on the Control Panel reads Ready.
2. Press the Utility button on the Control Panel.
3. In the Touch Panel, press the Controller Detail button.
4. Press the Menu button.
Guide.
C C P
AL FROM THE ONTROL
ColorCal
ANEL