EFI KM-C1530 Color Manual page 56

2
2-22 Color Calibration
4. Click Print in the Generate Measurement Page pane.
5. Retrieve the Measurement Page from the copier.
6. Click Measure in the Get Measurements pane.
If you chose the AutoCal method, skip to
If you chose the ColorCal method, an alert message appears, asking if you want to
calibrate the copier's scanner.
7. If you are using ColorCal and want to calibrate the scanner, click Yes.
8. Place the Kodak Gray Scale strip, Kodak Color Control Patches strip, and scanner
measurement page in the correct positions on the copier glass for scanner calibration.
Place the Gray Scale strip face down on the copier glass so that it will be centered along
the top edge of the scanner measurement page. Then place the Color Scale strip face
down on the copier glass so it is centered below the Gray Scale strip, keeping a distance
of 0.25 inch to 0.5 inch between the two strips. Finally, place the scanner
measurement page face down over the strips.
To perform the scanner calibration, click Continue in the dialog box that appears.
After the scanner has been calibrated, another dialog box appears, prompting you to
calibrate the Fiery X3e.
step 9.