EFI KM-C1530 Color Manual page 46

2
2-12 Color Calibration
8. Click Measure.
9. If necessary, choose the appropriate COM port for the DTP41 from the Available Ports
menu. Click Start Measurements.
10. Feed the measurement page into the DTP41, starting with the cyan strip.
Align the page in the measurement page slot of the DTP41 so the appropriate color
column is centered below the alignment mark (see the diagram on
the page about 3 inches, past the front idler rollers, until it rests against the rear
drive rollers.
page A-2). Insert