EFI KM-C1530 Color Manual page 81

3
3-21 Color Editor
7. If the output profile contains edit points that were entered by a user, choose Proceed
to remove the points and continue with the AutoGray adjustment.
Proceed starts a fresh AutoGray session by first removing all user edit points. This is
because AutoGray cannot modify user-entered points.
8. Click OK to confirm printing of the measurement page.
9. Retrieve the page from the copier.
10. Follow the directions in the dialog box for placing the Kodak Gray Scale strip and the
AutoGray measurement page on the copier glass, and click Continue.
Messages display the progress of the gray balance adjustment.
11. When the adjustment is complete, click OK.
Color Editor displays the adjusted output profile curve. New edit points have been
inserted by AutoGray to modify the gray balance, in much the same way an expert user
would have done manually.
12. To make edits to the output profile curve, click AutoGray again.
13. Choose Refine to fine-tune the curve, or New to acquire a new curve for editing.
For more information on these steps, see page 3-20.