EFI KM-C1530 Color Manual page 47

2
2-13 Using Calibrator
11. Click Read Strip.
The DTP41 pulls the measurement page through automatically.
After the measurement page is read, Calibrator instructs you to insert and align the
page again for the next color.
12. Repeat the measurement process for the magenta, yellow, and black strips.
A check mark appears on the circle of the color just read, and the Status field indicates
the color was measured successfully.
Use the Previous and Next buttons to reverse or advance to another step in the
measurement sequence.
13. When the Status field indicates that all four color strips have been read successfully,
click Accept Measurements.
14. In the Measure dialog box, click OK.
15. Click Apply in the Calibrator window to implement the new calibration set.
16. Click OK in the Information dialog box.
This completes the Fiery X3e calibration process.