EFI KM-C1530 Color Manual page 58

2
2-24 Color Calibration
5. Use the down arrow button to scroll to Calibration.
6. Choose Set Up Calibration.
7. For Calibration Mode, choose Standard or Expert.
8. For Measurement Method, choose AutoCal or ColorCal.
9. Choose Calibrate.
10. Select the Calibration Set.
11. When prompted, choose Yes to print the measurement page.
12. Choose Yes in the Measure Page screen.
13. When prompted on the Control Panel, place the Kodak Gray Scale strip face-down on
Place grayscale strip face down
If a password is set on the Fiery X3e, enter it and press OK.
With Expert Mode, you can print a Comparison Page (see
Choose from the list of all calibration sets on the Fiery X3e. This prompt appears only
if more than one calibration set is available.
This page is comprised of swatches of color that will be measured by the copier's
scanner and then compared to the target color values. After the page is printed, the
Measure Page screen appears.
the copier glass.
Place the strip along the top edge of the copier so that it is centered between the paper
width marks on the copier.
page 2-8).
Place color measurement page face
down over grayscale strip