2
2-20 Color Calibration
When the patch has been measured successfully, a checkmark appears in the patch
preview in the Measurements window. The window identifies and highlights the next
patch to be measured.
10. Repeat
step 9
To retake a measurement, select the desired patch preview in the Measurements
window and measure the patch on the page using the ED-100.
You must take the measurements in the order outlined in the Measurements
N
:
OTE
window and on the measurement page.
11. When all the patches have been read successfully, click Accept.
12. Click Apply in the Calibrator window to implement the new calibration set.
13. Click OK in the Information dialog box.
This completes the Fiery X3e calibration process.
to measure each successive patch on the Measurement Page.