Installing A Drive In A Front-Access Shelf - HP Kayak XA-s02 User Manual

geron.bk : geron-2.fb4 Page 42 Sunday, March 22, 1998 5:03 AM
NOTE
Before Installing an
IDE Device
Before Installing a
SCSI Device
2 How to Install Accessories Inside Your PC Workstation
Installing Mass Storage Devices
3 If an error message appears, follow the instructions provided by the
Error Message Utility. When prompted, press
program.
4 Select the Advanced menu, and the IDE Devices submenu. In the
Primary Master item, check that the details for the device have been
correctly detected by the Setup program.
5 Press to save and exit Setup.
Refer to the operating system documentation for information on
formatting a drive.
If an IDE drive is removed, switch on the computer. The system BIOS
will detect that the device is missing. Press
to remove the device. The system configuration will be updated
automatically.

Installing a Drive in a Front-Access Shelf

These instructions explain how to install a drive (such as a flexible disk
drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of the
front-access drive shelves. You should also refer to the manual supplied
with the drive for any additional installation instructions.
Refer to the drive's installation guide to see if you must set jumpers or if
there is a special installation procedure to follow.
If you are installing a SCSI device, refer to the section "Before Installing
a SCSI Hard Disk" on page 35 before using the following instructions.
1 Disconnect the computer's power cord and any telecommunications
cable.
2 Remove the computer's cover (see page 23).
3 Slide out the power supply to provide better access to the disk drive
cables (see page 27).
42 English
to run the Setup
to confirm that you want