Installing A Drive In A Front-Access Shelf - HP Kayak XA-s 02xx Manual

Before Installing an
IDE Device
Before Installing a
SCSI Device
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Desktop PC Workstation
Installing Mass Storage Devices

Installing a Drive in a Front-Access Shelf

These instructions explain how to install a drive (such as a floppy disk
drive, CD-ROM drive, CD-RW drive, or tape drive) in one of the front-
access drive shelves. You should also refer to the manual supplied with
the drive for any additional installation instructions.
Refer to the drive's installation guide to see if you must set jumpers or
if there is a special installation procedure to follow.
If you are installing a SCSI device, refer to "Before Installing a SCSI
Hard Disk" on page 12, before using the following instructions.
1 Disconnect the computer's power cord and any telecommunications
cable.
2 Remove the computer's cover (refer to page 3).
3 Remove the metal filler plate from the front of the PC Workstation's
case.
18 English
Remove the meta
filler plate.