Installing A Drive In A Front-Access Shelf - HP Kayak XA 05xx Installation Manual

When an IDE Drive
Is Installed
NOTE
Before Installing an
IDE Device
Before Installing a
SCSI Device
HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC Workstation
1 Switch on the computer.
2 To display the device in POST, press
re-starts.
3 If an error message appears, follow the instructions provided by the
Error Message Utility.
4 To verify the configuration of your hard disk drive, press
Setup when prompted. Once in Setup, select the
then the
IDE Devices
details for the device have been correctly detected by the Setup
program.
5 Press to save and exit Setup.
F3
Refer to the operating system documentation for information on
formatting a drive.
If you have removed an IDE drive, switch on the computer. The system
BIOS will detect that the device is missing. Press
want to remove the device. The system configuration will be updated
automatically.

Installing a Drive in a Front-Access Shelf

These instructions explain how to install a drive (such as a flexible
disk drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of
the front-access drive shelves. You should also refer to the manual
supplied with the drive for any additional installation instructions.
Refer to the drive's installation guide to see if you must set jumpers or
if there is a special installation procedure to follow.
If you are installing a SCSI device, refer to the section "Before Installing
a SCSI Hard Disk" on page 11 before using the following instructions.
1 Disconnect the computer's power cord and any LAN or
telecommunications cable.
2 Remove the computer's cover (see page 3).
Esc
submenu. In the
Primary Master
Installing Mass Storage Devices
while the PC Workstation
to enter
F2
menu,
Advanced
item, check that the
to confirm that you
F4
English 17