HP Kayak XA-s02 User Manual page 63

geron.bk : geron-2.fb4 Page 51 Sunday, March 22, 1998 5:03 AM
Completing the
Installation of a
Processor
NOTE
NOTE
1 Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus speed
and processor speed. Refer to the manual supplied with the processor
to verify which bus and processor speeds are supported.
Switch 1 Switch 2 Switch 3
1
UP UP UP
UP UP UP
UP UP DOWN
UP UP DOWN
UP UP DOWN
1. UP=OFF, DOWN=ON.
2 Install any other accessories before completing the installation of the
processor.
3 Replace the cover (see page 25).
4 Turn on the computer and check that the new processor is
recognized by the power-on system-test.
To fully benefit from dual processing, you will need to re-install
Windows NT 4.0 on your PC Workstation.
2 How to Install Accessories Inside Your PC Workstation
Switch 4 Switch 5 Bus
Speed
DOWN UP 66 MHz
DOWN DOWN 66 MHz
UP UP 66 MHz
UP DOWN 66 MHz
DOWN UP 66 MHz
Installing a Processor
Processor
Speed
333 MHz
350 MHz
400 MHz
450 MHz
500 MHz
English 51