Installing A Hard Disk Drive In A Front-Access Shelf - HP Kayak XU03 Installation Manual

Data Cable
NOTE
HP Kayak XU 03xx PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Mass Storage Devices
9 Connect the power cable and the data cable to the rear of the drive.
(The connectors are shaped to go in one way only.)
10 Install any other accessories before completing the installation.
11 Turn to page 21 to complete the installation.

Installing a Hard Disk Drive in a Front-Access Shelf

To ensure your hard disk drive is properly located and cooled, you
should only install drives that are up to one inch (1") in height and of a
speed equal to or less than 7200 rpm in this shelf.
1 Disconnect the computer's power cord and any telecommunications
cable.
2 Remove the computer's cover (refer to page 3).
3 Remove the fan connection to the system board (refer to page 6).
4 Press the retaining buttons on each side of the HP UltraFlow airflow
guide and lift it out of the PC Workstation's case.
5 Slide out the power supply to provide better access to the disk drive
cables (refer to page 6).
6 Unscrew and remove an unused drive tray.
18 English
Power Cable
Remove the
drive tray