Smt Version 6.2 - Cabletron Systems 3F00-01 User Manual

Chapter 3: Configuring the 3F00-01 and 3F55-01

3.1.1 SMT Version 6.2

Some of the SMT version 6.2 MIB variables (
their access types extended from Read-Only to Read-Write. These
variables can be written to, using a Network Management Station (NMS).
The variables with extended access include:
•
snmpFddiSMTStationId
identifier (corresponds to ANSI
bytes to zero will cause the unit to automatically use the port's MAC
address in the lower six bytes.
•
snmpFddiMACTMax
). Possible values range from 32 to 2,097,120.
fddiMAC 53
•
snmpFddiMACTvxValue
ANSI
fddiMAC 54
•
snmpFddiMACFrameCts
). Any attempt to write this parameter will cause the MAC's
fddiMAC 71
,
Frame_Ct Error_Ct
•
snmpFddiMACErrorCts
). Any attempt to write this parameter will cause the MAC's
fddiMAC 81
,
Frame_Ct Error_Ct
•
snmpFddiMACFrameErrorThreshold
fddiMACFrameErrorThreshold
).
95
Variables in the SMC enterprise MIB can be set to specify under what
conditions traps should be sent to an NMS. (Refer to the ATX MIB
Reference Guide for more detailed information.) Those variables include:
•
sfddiSmtConditions
the NMS via SNMP traps.
•
sfddiSrfConditions
the NMS via SNMP traps.
In the SMC enterprise MIB, you can set a variable to connect to port B:
•
sfddiThruB
for single-attached stations).
Page 3-2
– The port's unique eight byte SMT station
– The MAC's value for
– The MAC's value for
). Possible values range from 255 to 65,025.
– The MAC's
, and
Lost_Ct
– The MAC's
, and
Lost_Ct
– SMT conditions which should be reported to
– SRF conditions which should be reported for
– Whether to connect to the FDDI port B (not applicable
FDDI Dual-Attached Intelligent Module User's Guide
snmpFddiSMT 2
). Setting the lower six
fddiSMT 11
T_Max
Frame_Ct
to be zeroed.
Error_ Ct
to be zeroed.
– Value for the
variable (corresponds to ANSI
) have had
(corresponds to ANSI
(corresponds to
Tvx
(corresponds to ANSI
(corresponds to ANSI
fddiMAC