Cabletron Systems 3F00-01 User Manual page 61

5. Remove the installed module by pulling gently, but firmly, on the ears
at the ends of the module's front panel.
6. Gently slide the new module into the plastic guides in the module slot
until it's completely inserted. Push the module firmly into place, as far
as it will go, to fully engage the connectors at the back of the module
with the backplane at the rear of the ATX chassis.
7. Tighten the screws on each side of the module's front panel.
8. If you took the original module offline by pressing the OFFLINE
button, the new module will automatically come back online when it
is inserted in the slot.
If you used the Local Console Manager
original module offline, you must use the
the new module online.
9. Check the module LED power-on sequence as described in Chapter 2,
Connecting to the Network.
10. Make the connections to the network as described in Chapter 2.
FDDI Dual-Attached Intelligent Module User's Guide
Chapter 6: Adding/Swapping Modules
offline
online
command to take the
command to bring
Page 6-3