Program Recording - Kenwood MDX-F1 Instruction Manual

Contents
34

Program recording

Desired MD tracks can be programmed in the desired sequence and recorded onto a tape.
Recording preparation is required. º
1
Program the desired sequence of MD tracks.
Perform steps1 and 2 of the procedure in "Lis-
tening in the desired sequence (Program play-
back)".
2
Press the TAPE REC key twice to enter
record-pause mode.
0
3
Press the MD 6 key again.
(Start recording.)
0
To interrupt a recording
0
(Recording and playback will be
stopped.)
(MD = TAPE)
™
(Press twice.)
•
TAPE REC
MD
6
STOP
7
(Be sure to put the cassette deck in stop mode.)
÷ When the PGM key is pressed to cancel the edited
contents, the entire editing contents will be erased.
÷ Tracks programmed in excess of the tape recording time
will be cut off.
÷ Starting the MD program playback starts tape recording
by synchro recording.
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
Convenient Recording Methods
corded portion of about 4 sec. has
been produced.
MDX-F1 (EN)