Setting The Current Time - Kenwood MDX-F1 Instruction Manual

Setting the current time

The current time of the day must
be set before using the timer.
Preparation
Press the power (
power on.
(Main unit)
1
Press and hold the MENU key for more
than 2 seconds.
2
Enter the figure of hour.
1
To decrease
hour
2
3
Enter the figure of minute.
1
To decrease
minute
2
To display the time
(In standby mode)
) key to turn
STANDBY
/TIMER
MENU
To increase
hour
SET
To increase
minute
SET
STOP
7
(Displayed for 5 sec.)
÷ The "CLOCK" display starts to blink during time setting.
PGM
AM
A D J U S T
÷ The time display starts to blink.
Example: Adjustment to 8:07
PGM
AM
A D J U S T
÷ The time of the day is represented in 12-hour AM/PM
method.
÷ Press the SET/Demo key. The hour is entered and the
minute display starts to blink.
Example: Adjustment to 8:07
PGM
AM
A D J U S T
÷ If you make a mistake, restart from the beginning.
÷ To adjust correct time, press the SET/Demo key at the
same moment as a time announcement.
÷ After a power failure of more than 10 minutes or the
power cord has been unplugged for more than 10 min-
utes, the current time should be set again.
÷ When the time of day has been set by pressing the SET/
Demo key, the display shows "COMPLETE !".
÷ " : " (colon) blinks when the time of day has already
been set.
Contents
Controls and indicators
MDX-F1 (EN)
2 3
1 1
1
0
2 3
2 2
A.P. S.
STE
1 2 0 0
A.P.S.
STE
8 0 0
A.P.S.
STEREO
8 0 7
9
REC
REC
REC
REC
REC
REC