To Wind Tape At High Speed; To Stop Playback; Selection Of Reverse Mode; Selection Of Tape Eq - Kenwood MDX-F1 Instruction Manual

To wind tape at high speed

To fast wind in
direction |
0

To stop playback

0

Selection of reverse mode

1 Select "TAPE RVS?" from the menu.
MENU
2 Select.
" " : (REVERSE)
" ": (ONE-WAY)
3 Set it.

Selection of TAPE EQ.

To fast wind in
direction \
4 ¢
STOP
7
(Main unit only)
SET
Press the "SET/Demo"
key while the "?" mark
is blinking.
" ":
(ENDLESS)
SET
(Remote control unit only)
TAPE EQ.
If you are operating the remote control unit, press
the 1 or ¡ key.
1
TUNING
÷ Press the 7 key to stop fast winding.
÷ Do not take out the cassette tape until the tape
transport has stopped completely.
Tape counter display
Each press of the TIME DISPLAY key changes
the displayed contents.
0 0 0 0
1
AM
2
8 4 5
AM
The tape counter is set to "0000" when a cassette tape is
loaded.
By writing down the counter reading in case you want to
interrupt recording (playback) in the middle of the tape,
the memo will be helpful as a reference for locating the
same position when continuing the recording (playback)
the next time. The tape counter figure decrements dur-
ing recording or playback of the back side (while the 2
tape transport indicator is lit).
To set the tape counter to "0000", open the cassette
holder once.
Then the counter will be reset.
" " : (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
" " : (REVERSE)
Both sides are played back (recorded), and then the
tape stops. (Initial setup)
" " :
(ENDLESS)
Both sides are played back endlessly. (The tape
stops after recording onto both sides.)
The tape stops after recording onto both sides.
The TAPE EQ. system minimizes the hiss noise heard
when playing tape. When playing a tape prerecorded
with Dolby NR ON, be sure to set the TAPE EQ. ON
for playback.
Lit when "TAPE EQ." is ON
Each press switches the modes as follows.
1 "TAPE EQ." Light ......... TAPE EQ. is used.
2 "TAPE EQ." Goes off ... TAPE EQ. is not used.
÷ Select the TAPE EQ. mode according to the recording
condition of the tape.
Contents
Playback of tape

MDX-F1 (EN)

1
(Remote control unit only)
(Tape count)
(Time display)
TAPE EQ.
25