Download  Print this page

Cd Player Section - Kenwood MDX-F1 Instruction Manual

Minidisc personal stereo system
Hide thumbs

Advertisement

Table of Contents

CD player section

Symptom
A CD is placed in the player but
it cannot be played.
Sound is not produced.
Sound skips.
Cassette deck
Symptom
Sound cannot be produced by
pressing the play key.
No operation occurs even
when an operation key is
pressed.
The cassette holders cannot
be opened by pressing the "0
push OPEN" button.
Sound is harsh or high fre-
quencies are not reproduced.
Noise is noticeable.
Recording cannot be started
by pressing the record key.
Cause
÷ The disc is placed upside down.
÷ The disc is extremely dirty.
÷ Dew is condensed on the optics lens.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ The disc is dirty.
÷ The player is subject to vibration.
Cause
÷ The head is dirty.
÷ The tape is wound too tight due to
irregular winding.
÷ A nonrecorded tape is played.
÷ The cassette holder is not closed com-
pletely.
÷ The operation key is pressed in less than
4 seconds after turning the power ON.
÷ The tape is wound too tight due to
irregular winding.
÷ The key is pressed during recording or
playback.
÷ The microcomputer is malfunctioning
due to external noise.
÷ The head is dirty.
÷ The tape is stretched or shrunk.
÷ The tape head is magnetized.
÷ A tape recorded with Dolby NR ON is
played with TAPE EQ. OFF.
÷ The recording protect tab of the cas-
sette has been broken.
÷ The cassette holder is not closed com-
pletely.
÷ The TAPE input is selected.
÷ The tape is fully wound to one of the reels.
In case of difficulty
Remedy
÷ Place the disc properly, with the label
side facing upward.
÷ Clean the disc referring to "Disc han-
dling precautions".
÷ Refer to "Caution on condensation" and
remove the condensation by evaporation.
÷ Clean the disc referring to "Disc han-
dling precautions".
÷ Try another disc.
÷ Clean the disc referring to "Disc han-
dling precautions".
÷ Install the unit in a place not subject to
vibrations.
Remedy
÷ Clean the head referring to "Cleaning
the head section".
÷ Try another tape.
÷ Play a recorded tape.
÷ Close the holder completely.
÷ Press operation keys after waiting for
more than 4 seconds.
÷ Try another tape.
÷ Press in stop mode.
÷ Reset the microcomputer.
÷ Clean the head referring to "Cleaning
the head section".
÷ Try another tape.
÷ Demagnetize the head referring to
"Cleaning the head section".
÷ Set the TAPE EQ. to on.
÷ Use a cassette with an unbroken record-
ing protect tab or block the hole.
÷ Close the holder completely.
÷ Set the input selector to the source to be
recorded.
÷ Change the tape transport direction or
reverse the tape insertion orientation.
Contents
55
MDX-F1 (EN)
p
o
p
p
i
¢
W
i
i
Q
¢
º
¢

Advertisement

Table of Contents
loading

  Also See for Kenwood MDX-F1

  Related Manuals for Kenwood MDX-F1