Recording On Tape - Kenwood MDX-F1 Instruction Manual

Contents
30

Recording on TAPE

1
Load a tape in deck.
0
2
Select the tape transport direction.
TAPE
2 3
3
Set the recording condition.
Select the reverse mode.
4
Select the source to be recorded.
Select an input source
other than "TAPE"
CD
6
Example:
To select the CD input
5
Start recording.
•
TAPE REC
1 Open the door of deck.
2 Insert a tape.
3 Close the door.
To reverse the transport direction
1 Press the play key.
2 Press the play key again.
3 Stop key (7) playback.
(2 or 3 lights.)
1 Select "TAPE RVS.".
∞
MENU
TUNER (Broadcasts)
CD
MD
1 Press the TAPE REC key to start recording.
2 Play (or tune) the input source to be recorded.
÷ The recording level is adjusted automatically.
÷ Recording stops automatically when the tape side (s) to be recorded have
been fully recorded.
÷ The recording onto MD is not available during recording onto TAPE.
This unit cannot record audio on High (Type ) and
Metal (Type ) cassette tapes.
4
÷ Remove tape slack before loading.
÷ When recording is started, the tape is
÷ Wind the tape to the position where
SET
C D
The character information display shows
the recording input source.
÷ If a CD or MD has already been loaded, it starts to play now.
Press the 7 key to stop it.
Let's recording
3
2
0
1 5
transported in the direction selected in
this step.
recording is to be started.
2 3
MDX-F1 (EN)
SET